MUTOH Rockhopper II series Maintenance Manual page 112

Step 8 :
Remove the connector and tube from the maintenance assembly.
1 = tube connections
Notes :
Step 9 :
Remove the 6 screws fixing the maintenance assembly.
1 = Waste fluid receptacle
3 = Screws (M3x8) fixing the maintenance assembly
Step 10 :
Replace the maintenance assembly.
Notes :
There is some remaining ink in the tubes. Be careful that the ink is not spilled from
the tube onto the printer or items close to the printer.
Secure the maintenance assembly so that it abuts against the rear right portion.
If the cap tube has not been cut, cut it to the length below, measured from the end
of the tube: Numbers in brackets ( ) are the cap numbers from left to right as viewed
from the front of the main body. For 50, 64 inch model: (1) 50mm, (2) 0mm, (3)
40mm, (4) 0mm For 87 inch model: (1) 90mm, (2) 50mm, (3) 40mm, (4) 70mm,
(5) 0mm, (6) 30mm, (7) 30mm, (8) 0mm
The connection sequence for the tubes is as follows: Numbers in brackets ( ) are
the cap numbers from left to right as viewed from the front of the main body.
Rockhopper II series printers – Maintenance Manual
2 = Maintenance assembly
113 AP-74065, Rev. 1.2, 27/09/04