MUTOH Rockhopper II series Maintenance Manual page 93

Step 5 :
Completely remove tube bundles 1 and 2.
1 = Tube bundle
Step 6 :
Remove the 4 screws fixing the tube clamp.
Step 7 :
Remove the tube clamp.
Step 8 :
Remove the coupling screws, O-ring and ink tube from the coupling.
Step 9 :
Replace the ink tube.
Step 10 :
Remove the 2 screws fixing the cable clamp.
Step 11 :
Replace the steel bearing.
Step 12 :
Replace the tube guide.
Step 13 :
Remove the pipe clamp.
Step 14 :
Replace the CR tape power cable.
1 = Tube push plate
2 = Pipe clamp
4 = Screws fixing tube push plate (M3x8)
Step 15 :
Reinstall all parts in the opposite order of the removal procedure.
Notes :
The CR tape power cables must be bundled during installation so that they can not
move.
The edge of the tube push plate must be upside when installed.
You should soak the O-ring in cleaning liquid once gain before installing it.
Rockhopper II series printers – Maintenance Manual
2 = Tube bundle 2
2 = Cable clamp
3 = Coupling, O-ring, coupling screws
4 = Screws fixing tube cramp (M3x20)
94 AP-74065, Rev. 1.2, 27/09/04