MUTOH Rockhopper II series Maintenance Manual page 89

Step 5 :
Remove the T fence from the hook.
Step 6 :
Pull out the T fence in the direction of the arrow as shown in the previous figure while being
careful not to damage the CR_ENC assembly.
Step 7 :
Reinstall all parts in the opposite order of the removal procedure.
Notes :
1 = T fence push plate
3 = CR_ENC assembly
When installing the T fence, pay attention to the following :
When there is a film on the T fence, remove the film and install the T fence.
Properly install the T fence to the hooks on the T fence stationary plate.
Refer to the figure in step 2.
The T fence and the hooks on the stationary plate must have a loose fit.
When securing the stationary plate with screws, it must be loosened
enough so the T fence can be moved.
Insert the T fence into the hooks on the T fence push plate and the
CR_ENC assembly. Refer to the following figure.
Fix the T fence spring hook so that distance A of following diagram is about
1mm.
Rockhopper II series printers – Maintenance Manual
2 = T fence
4 = T fence spring hook
90 AP-74065, Rev. 1.2, 27/09/04