Cutter Endurance Menu - MUTOH Rockhopper II series Maintenance Manual

5.9.3. Cutter Endurance menu

This menu performs endurance running for the cutter.
You can perform the cutting operation according to the settings.
Caution :
Pay attention to the following points when performing the cutter endurance operation.
Performing the cutter endurance operation without ink cartridges could result in damage
to the product if the cutter fails outside the cutting range.
The available settings are shown below.
Setup item
Page size
Number of endurance
running cycles
Waiting time
Notes :
Install usable ink cartridges.
Make sure that media initialization is complete.
Description
Sets amount of media feeds per
endurance operation.
Set the number of endurance
running cycles
Set the waiting time after one
cycle of endurance running
If the number of endurance running cycles is set to -1, the units continuously repeat
endurance running until a key input is given from the operation panel.
The maximum counter value for endurance running cycles is 99999999 (up to 8-digit
number). If the number of cycles exceeds the maximum value, the counter is reset
to 0.
The waiting time is not modifiable.
* Page size *
↓ ENTER
* Cutter *
Count
↓ ENTER
* Cutter *
Time Wait (sec)
↓ ENTER
Rockhopper II series printers – Maintenance Manual
Parameters
30 to 3000
-1 to 10000
40
30 – 3000 mm + Page size
30 mm -
-1 → 10000 + Count Endurance
50 -
40 Check Waiting time
188
Remarks
Unit: mm
Unit: second
AP-74065, Rev. 1.2, 27/09/04