MUTOH Rockhopper II series Maintenance Manual page 263

Maintenance Maintenance assembly
components
Pump Combined gear
Components
Deceleration gear
Idler gear
Idler gear axis
Winding Winding assembly (gear
components components)
PF Driving Set screw
Components
CR Driving Adjusting screw of the CR
Components slave pulley
Cursor Step-bore screw
Components
Maintenance E ring
components
Scroller Set screw
receptacle R
components
Others Screw
PF Driving CR tape power cable
Components
Head base Head 2 tape wire
components
Pump Pump assembly
Components
Others Locations where sharp
edges are likely to occur
Rockhopper II series printers – Maintenance Manual
Apply to the gear
and cam
components
Apply to the gear
components
Apply to the gear
components
Apply to the gear
components
Apply between the
pump base and the
idler gear axis.
Apply to the gear
components
Apply the screw lock
to the coupling set
screw.
After adjusting the
steel belt, apply the
screw lock.
Screw lock applying
to the shoulder
screw that fastens
the cursor and head
mounting plate
Apply to each of the
E-rings (prevents
noise due to
vibration).
Apply the screw lock
to the adjusting
knob set screw.
Apply to the position
of the screw lock.
Stick double-sided
tape to the CR tape
power cables
(locating).
Stick double-sided
tape to the head 2
tape power cables
(locating and
preventing
floatation).
Acetate tape is fixed
to the pump
assembly tube
(prevents dislodging
of tube).
Acetate tape is fixed
to tape electrical
wires and
harnesses, where
sharp edges are
likely to occur
(sharp edge
protection).
264
Kanto Kasei Co., FLOIL G-MK-1
Ltd.
Kanto Kasei Co., FLOIL G-MK-1
Ltd.
Kanto Kasei Co., FLOIL G-MK-1
Ltd.
Kanto Kasei Co., FLOIL G-MK-1
Ltd.
Kanto Kasei Co., FLOIL G-MK-1
Ltd.
Kanto Kasei Co., FLOIL G-MK-1
Ltd.
Three Bond Co., 1401
Ltd.
Three Bond Co., 1401
Ltd.
Three Bond Co., 1401
Ltd.
Three Bond Co., 1401
Ltd.
Three Bond Co., 1401
Ltd.
Three Bond Co., 1401
Ltd.
Not specified
Not specified
Not specified
Not specified
AP-74065, Rev. 1.2, 27/09/04