MUTOH Rockhopper II series Maintenance Manual page 105

Notes :
Step 4: There are grooves between the different print platform plates. Cut the black strip at this place
equal with this groove.
Important :
Make sure that the black tape connects properly.
Please make sure that there are no air bubbles under the black tape. Air bubbles
below the black tape could cause the black tape to come loose.
Make sure not to cut the heater strip below the print platform. Doing so will
damage the printer.
Rockhopper II series printers – Maintenance Manual
1 = groove
106 AP-74065, Rev. 1.2, 27/09/04