Replacing The Transmission Photosensor - MUTOH Rockhopper II series Maintenance Manual

4.5.8. Replacing the transmission photosensor

Notes :
(1) Replacing the transmission photosensor (lever motor side)
Step 1 :
Remove the screw fixing the sensor installation board.
1 = Sensor installation board
Step 2 :
Remove the sensor installation board.
Step 3 :
Remove the transmission photosensor from the sensor installation board.
1 = Sensor installation board
3 = Transmission photosensor
Step 4 :
Remove the connector from the transmission photosensor.
Step 5 :
Remove the transmission photosensor.
Step 6 :
Apply the screw lock to the tab portions of the transmission photosensors to be installed.
Step 7 :
Reinstall all parts in the opposite order of the removal procedure.
Notes :
Remove following covers before replacing the transmission photosensor.
Side cover R: refer to "Removing side cover R"
Side cover L: refer to "Removing side cover L"
Front cover: refer to "Removing the front cover"
Carriage cover: refer to "Removing the carriage cover"
Y rail cover: refer to "Removing the Y rail cover"
When installing the U/D cable assembly onto the transmission photosensor, be
careful not to confuse the connectors.
Lever up cable assembly (white): front
Lever down cable assembly (blue): rear
Rockhopper II series printers – Maintenance Manual
2 = Screw (M3x8) fixing the sensor installation board
2 = Connector
82 AP-74065, Rev. 1.2, 27/09/04