MUTOH Rockhopper II series Maintenance Manual page 82

(2) Replacing the transmission photosensor (CR origin side)
Notes :
Step 1 :
Unlock the head.
Step 2 :
Move the carriage from the capping position to the left.
Step 3 :
Remove the transmission photosensor from the ORG sensor installation board.
1 = ORG sensor installation board
3 = Transmission photosensor
Notes :
Step 4 :
Remove the connector from the transmission photosensor.
Step 5 :
Remove the transmission photosensor.
Step 6 :
Apply the screw lock to the tab portions of the transmission photosensors to be installed.
Step 7 :
Reinstall all parts in the opposite order of the removal procedure.
Refer to 'Head Lock Menu'
The ORG sensor installation board has been adjusted at the origin in factory. Do
not loosen the fixed screws.
Rockhopper II series printers – Maintenance Manual
2 = Connector
83 AP-74065, Rev. 1.2, 27/09/04