MUTOH Rockhopper II series Maintenance Manual page 55

Step 7 :
Remove the front heater strip(s).
Step 8 :
Degrease the plate.
Notes :
Step 9 :
Stick the front heater strip(s) onto the plate.
Notes :
Notes :
Step 10 :
Stick onto the sensor an isolation strip.
Step 11 :
Reinstall all parts in the opposite order of the removal procedure.
Notes :
Make sure the plate is cleaned properly. Dust, glue and other parts must be
removed.
Make sure that the strips connect properly.
Please make sure that the sensor (blue blocks) are positioned on the flat surface of
the front paper guide.
Please make sure that there are no air bubbles under the heater strip. Air bubbles
below the heater strip could cause overheating of the heater strip.
During reinstallation of the plate, make sure there are no cables stuck.
Rockhopper II series printers – Maintenance Manual
56 AP-74065, Rev. 1.2, 27/09/04