MUTOH Rockhopper II series Maintenance Manual page 181

(5) Mechanical parameter
Update the mechanical position parameters. The setup items are as follows.
Top distance
Bottom distance
Side margin
P_REAR sensor position
* Mechparm *
Top Length
* Mechparm *
Bottom
* Mechparm *
Side
* Mechparm *
Rear Sensor
* Mechparm *
Update Parameter
* Mechparm *
Updating Parameter
Rockhopper II series printers – Maintenance Manual
0 – 40.0 +
5.0 mm -
0 – 40.0 +
5.0 mm -
0 – 20.0 +
5.0 mm -
0 – 27.0 +
17.0 mm -
↓ ENTER
↓ ENTER
182 AP-74065, Rev. 1.2, 27/09/04