Removing The Y Rail Cover - MUTOH Rockhopper II series Maintenance Manual

4.2.7. Removing the Y rail cover

Caution :
Removing the Y rail cover, should be performed by at least two persons.
Otherwise the Y rail cover may be deformed.
Step 1 :
Remove side cover R.
Step 2 :
Remove side cover L.
Step 3 :
Remove the front cover.
Step 4 :
Remove the carriage cover.
Caution :
Please note that this cover is only on a Rockhopper II (2 heaters) printer.
Step 5 :
Remove the 3 screws fixing the Y rail cover and the Y rail cover FG.
1 = Y rail cover FG
Step 6 :
Remove the 6 screws from the front of the Y rail cover.
1 = Screws (M4x8) on the front of the Y rail cover
Rockhopper II series printers – Maintenance Manual
2 = Screws (M3x6) fixing the Y rail cover and the Y rail cover FG
48 AP-74065, Rev. 1.2, 27/09/04