Top & Bottom Adjustment Menu - MUTOH Rockhopper II series Maintenance Manual

5.5.8. Top & bottom adjustment menu
Sets printing margins.
Make adjustments following the steps below.
Step 1 :
Set media as necessary.
Step 2 :
After the media has been set, pattern printing with band feed compensation and media cutting
are performed. The following is the description of the printing method.
Black, one path, one-way
Step 3 :
Measure the following adjustment items for the results of the printing of the top & bottom
adjustment pattern.
Measurements are carried out at the center of the media. The adjustment items are as follows.
Top distance
Bottom distance
Side margin
Step 4 :
Input each measurement as a parameter.
* Top&Bottom *
Set Paper
* Top&Bottom *
Paper Initial
* Top&Bottom *
Adjustment Print
* Top&Bottom *
Top Length
* Top&Bottom *
Top Length
* Top&Bottom *
Side
Rockhopper II series printers – Maintenance Manual
If media is not set
↓ Set media
↓ End Media Initialization
Display during adjustment printing
0 – 40.0 +
5.0 mm -
0 – 40.0 +
5.0 mm -
0 – 20.0 +
5.0 mm -
168
1: Top distance
2: Bottom distance
3: Side margin
4: Media feed direction
AP-74065, Rev. 1.2, 27/09/04