MUTOH Rockhopper II series Maintenance Manual page 274

11 Hard disk
status connect
error
12 Network
initialize error
13 Waste ink tank
sts. No
There is a problem
in the hard disk
connections.
There is a problem
in the network
board.
The waste tank is
not installed.
Rockhopper II series printers – Maintenance Manual
(2) The number of • Replace the print
times the print head assembly.
head was used • Initialize the head
reached the unit.
maximum
allowable times.
(3) If initialization • Replace the
does not take Mainboard
effect when the assembly.
head unit is
initialized, the
Mainboard
assembly may be
damaged.
(1) Check the • Redo the
connections of connections of the
connectors. following
connectors.
• Mainboard : J102
• power source
board (small)
assembly : CN51 –
CN52
(2) The • Replace the ink
HDD_MOTHER tube.
board assembly • Initializing CR
may be damaged. motor history.
(3) Hard disk may • Replace the hard
be damaged. disks.
(4) The Mainboard • Replace the
assembly may be Mainboard
damaged. assembly.
(1) The • Replace the
PCI_LINUX board PCI_LINUX board
assembly may be assembly.
damaged.
(2) The Mainboard • Replace the
assembly may be Mainboard
damaged. assembly.
(1) Check if the • Install the waste
waste bottle has bottle correctly.
been installed.
(2) Check the • Replace the
operation of the waste box sensor
waste box sensor assembly.
assembly via
"Sensor/Waste
Bin" of the self-
diagnostic
function.
275
→ Replacing the
print head
assembly and
head tape power
cable.
→ Counter
initialization
menu.
→ Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV
board assembly
and cooling fan
assembly
→ Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV
board assembly
and cooling fan
assembly.
→ Replacing the
power source
board assembly.
→ Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV
board assembly
and cooling fan
assembly.
-
-
AP-74065, Rev. 1.2, 27/09/04