MUTOH Rockhopper II series Maintenance Manual page 56

4.3.1.2. Replacing the rear heater on a Rockhopper II printer
Before replacing the post fixer, make sure to have following items:
50" model : Heater strip assy rear 50
64" model : Heater strip assy rear 64
87" model : Heater strip assy rear 87
2 x press plate
Silicone glue
To replace the rear heater on a Rockhopper II printer, please follow the instructions mentioned below.
Step 1 :
Remove side cover L.
Step 2 :
Remove side cover R.
Step 3 :
Remove the front cover.
Step 4 :
Remove the Y rail cover.
Step 5 :
Remove the rear paper guide.
Step 6 :
Remove the rear heater strip.
Step 7 :
Degrease the plate.
Notes :
Step 8 :
Stick the rear heater strip onto the plate.
Step 9 :
Stick (with silicone glue) the two press plates onto the heater strip.
50" model : X = 380 mm
64" model : X = 380 mm / Y = 1060 mm
87" model : X = 660 mm / Y = 1200 mm / Z = 1750 mm
Make sure the plate is cleaned properly. Dust, glue and other parts must be
removed.
Rockhopper II series printers – Maintenance Manual
57 AP-74065, Rev. 1.2, 27/09/04