Replacing The Cr Cursor Assembly - MUTOH Rockhopper II series Maintenance Manual

4.7.8. Replacing the CR cursor assembly

Notes :
Step 1 :
Follow the instructions in "Replacing the cutter holder, cutter spring, cutter cap, solenoid
assembly, and solenoid spring" to "Replacing the P_EDGE sensor assembly " to remove the
parts in cursor components.
Step 2 :
Slide the CR cursor assembly to the opposite side of the home position.
Step 3 :
Follow the instructions in "Replacing the steel belt" to remove the steel belt from the CR cursor.
Step 4 :
Remove the 4 screws fixing the CR board installation board.
Step 5 :
Remove the CR board installation board.
1 = CR board installation board
Step 6 :
Remove the T fence.
Step 7 :
Remove the CR blade spring.
1 = CR cursor assembly
Step 8 :
Replace CR cursor assembly.
Step 9 :
Reinstall all parts in the opposite order of the removal procedure.
Step 10 :
Perform head height adjustment according to "Head height adjustment".
Remove following covers before replacing the CR cursor assembly.
Side cover R: refer to "Removing side cover R"
Side cover L: refer to "Removing side cover L"
Front cover: refer to "Removing the front cover"
Carriage cover: refer to "Removing the carriage cover"
Y rail cover: refer to "Removing the Y rail cover"
Head cover: refer to "Removing the head cover"
2 = Screws (M3x8) fixing the CR board installation board
Rockhopper II series printers – Maintenance Manual
2 = CR blade spring
107 AP-74065, Rev. 1.2, 27/09/04