Skew Check Menu - MUTOH Rockhopper II series Maintenance Manual

5.5.1. Skew Check Menu

In this menu, you can perform media feed and check the degree of skew in the media feed operation by
means of the sensors.
When you select this item from the Adjustment menu, the machine feeds the length specified by the
operation panel and checks for media feed skew by comparing the media edge positions before and after the
media feed detected by the sensors.
Notes :
Before performing skew check, ensure that the media is set correctly.
Since the reference position where media has been set is determined the first time the
media left edge is detected, errors may result as follows if the media is not setup
correctly.
Media errors occur during skew check and the operation stops.
"Undefined Media" occurs frequently during media initialization when the power is
turned on or media is cut.
* Check Skew *
* Check Skew *
Set Paper
* Check Skew *
Paper Initial
* Check Skew *
Exc. Skew
* Check Skew *
SkewResult
Rockhopper II series printers – Maintenance Manual
0.1 m – 10.0 m +
1.0 m -
↓ ENTER
↓ Media set
↓ Finishing media initialization
↓ Finishing media edge detection normally
+ 0.010 mm
151
Set per 0.1 m
When media is not set
AP-74065, Rev. 1.2, 27/09/04