MUTOH Rockhopper II series Maintenance Manual page 285

12 E 076 Error
PG CR origin
The HD_SLIDE
home position
cannot be detected.
Rockhopper II series printers – Maintenance Manual
(3) The print head •Replace the print
may be damaged. head assembly
(4) The CR board • Replace the CR
assembly may be board assembly
damaged. • Reset the head
error
(5) The Mainboard • Replace the
assembly may Mainboard
have a problem assembly
• Reset the head
error
(1) Check the • Make sure that
HD_SLIDE sensor the connections of
via the HD_SLIDE
"Sensor/HD_SLID sensor assembly
E" of the self- connectors are
diagnostic function good.
• Mainboard : J127
(2) Make sure that • Replace the
the connections of HD_SLIDE sensor
the HD_SLIDE assembly.
sensor assembly
connectors are
good.
(3) The SLIDE • Replace the
motor assembly SLIDE motor
may be damaged. assembly.
(4) The Mainboard • Replace the
assembly may Mainboard
have a problem. assembly.
286
→ Replacing the
print head
assembly and
head tape power
cable.
→ Counter
initialization menu
→ Replacing the
CR board
assembly
→ Counter
initialization menu
→ Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV
board assembly
and cooling fan
assembly.
→ Counter
initialization menu
→ Sensor Menu
→ Replacing the
SLIDE motor
assembly,
HD_SLIDE
sensor assembly
and slide motor
installation board.
→ Replacing the
SLIDE motor
assembly,
HD_SLIDE
sensor assembly
and slide motor
installation board.
→ Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV
board assembly
and cooling fan
assembly.
AP-74065, Rev. 1.2, 27/09/04