4.11.3. Replacing the waste bottle box sensor assembly (RH II 2H)
Step 1 :
Follow the instructions in "Replacing the waste fluid bottle assembly" to remove the waste fluid
bottle assembly.
Step 2 :
Remove the waste liquid BOX sensor assembly connector from the rear side cap R.
1 = Rear side cap R
Step 3 :
Remove the screws (3 at the front and 12 at the right and left) fixing the waste liquid bottle cover.
1 = Waste liquid bottle cover
Step 4 :
Remove the waste liquid bottle cover.
Step 5 :
Remove the screws (2) fixing the waste liquid sensor installation board.
1 = Screws fixing the waste liquid sensor installation board (M3x6)
Rockhopper II series printers – Maintenance Manual
2 = Waste liquid BOX sensor assembly connector
2 = Screws (M3x6)
129
AP-74065, Rev. 1.2, 27/09/04