Fuel And Hydraulic Tanks; Fuel Tank; Hydraulic Tank - Genie Z-45/25 Service Manual

First Edition • Second Printing
13-1

Fuel Tank

How to Remove the Fuel Tank
Explosion and fire hazard. Engine
fuels are combustible. Remove the
fuel tank in an open, well-
ventilated area away from heaters,
sparks, flames and lighted
tobacco. Always have an
approved fire extinguisher within
easy reach.
Explosion and fire hazard. When
transferring fuel, connect a
grounding wire between the
machine and pump or container.
All models:
1 Disconnect, drain and plug the supply and
return fuel hoses. Cap the fuel return fitting on
the fuel tank.
2 Remove the mounting fasteners from the top
and bottom of the fuel tank.
3 Remove the fuel tank from the machine.
Part No. 52709

Fuel and Hydraulic Tanks

13-2

Hydraulic Tank

The primary functions of the hydraulic tank are to
cool, clean and deaerate the hydraulic fluid during
operation. It utilizes internal suction strainers for
the pump supply lines and has an external return
line filter mounted to the engine side bulkhead. The
hydraulic return filter incorporates a filter condition
indicator.
How to Remove the
Hydraulic Tank
1 Locate the two hydraulic tank valves at the
hydraulic tank through the access hole
underneath the turntable, then close the valves.
Genie Z-45/25 & Genie Z-45/25J
Section 7 • Repair Procedures
Component damage hazard.
The work area and surfaces
where this procedure will be
performed must be clean and
free of debris that could get
into the hydraulic system.
When removing a hose assembly
or fitting, the O-ring on the fitting
and/or hose end must be replaced
and then torqued to specification
during installation.
Refer to Section Two, Hydraulic
Hose and Fitting Torque
Specifications.
open closed
7 - 77