Genie Z-45/25 Service Manual page 435

First Edition • Second Printing
5 Remove the lug nuts, then remove the tire and
wheel assembly.
6 Tag, disconnect and plug the hydraulic hoses
from the drive motor. Cap the fittngs on the
drive motor.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
7 Remove the drive motor mounting fasteners.
8 Slide the drive motor shaft out of the drive hub
and then remove the drive motor from the
machine.
9 Remove the pin retaining fasteners from the
upper and lower yoke pivot pins. Do not remove
the pins.
10 Support the yoke/drive hub assembly with a
lifting jack. Secure the yoke/drive hub assembly
to the lifting jack.
Part No. 52709
11 Place a rod through the upper yoke pivot pin
and twist to remove the pin, then use a soft
metal drift to drive the lower yoke pivot pin
down and out.
12 Place the yoke/drive hub assembly on a flat
surface with the drive hub facing down.
Genie Z-45/25 & Genie Z-45/25J
Section 7 • Repair Procedures
4WD STEERING AXLE COMPONENTS
Crushing hazard. The yoke/hub
assembly may become
unbalanced and fall when the yoke
pivot pins are removed if it is not
properly supported and secured to
the lifting jack.
7 - 87