Non-Steering Axle Components; Drive Motor - Genie Z-45/25 Service Manual

Section 7 • Repair Procedures

Non-steering Axle Components

18-1

Drive Motor

How to Remove a Drive Motor
Component damage hazard.
Repairs to the motor should only
be performed by an authorized
Sundstrand-Sauer dealer.
Component damage hazard. The
work area and surfaces where this
procedure will be performed must
be clean and free of debris that
could get into the hydraulic system
and cause severe component
damage. Dealer service is
recommended.
When removing a hose assembly
or fitting, the O-ring on the fitting
and/or hose end must be replaced
and then torqued to specification
during installation.
Refer to Section Two, Hydraulic
Hose and Fitting Torque
Specifications.
1 Remove the fasteners from cover on the non-
steer axle. Remove the cover.
7 - 90
2 Tag, disconnect and plug the hydraulic hoses
from the drive motor. Cap the fittings on the
drive motor.
3 Remove the drive motor mounting fasteners.
4 Slide the drive motor shaft out of the brake and
then remove the drive motor from the machine.
Torque specifications
Drive motor mounting bolts
Genie Z-45/25 & Genie Z-45/25J
First Edition • Second Printing
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to squirt
or spray.
75 ft-lbs
Part No. 52709
102 Nm