Genie Z-45/25 Service Manual page 106

Section 4 • Scheduled Maintenance Procedures
TABLE E PROCEDURES
Explosion and fire hazard.
Electronic Fuel Injection (EFI)
systems operate at a very high
pressure. Fuel may be expelled
under pressure if the hoses are
removed too quickly. Loosen the
fuel lines very slowly to allow the
fuel pressure to dissipate
gradually. Wrap a cloth around
fuel hoses to absorb leaking fuel
before disconnecting them.
a
e
Ford models
a high pressure hose from fuel pump to
regulator/filter
b hose from fuel pre-filter to fuel pump
c hose from fuel tank to fuel pre-filter
d high pressure hose from regulator/
filter to engine
e hose from regulator/filter to tank
4 - 76
c
b
d
Genie Z-45/25 & Genie Z-45/25J
First Edition • Second Printing
6 Clean up any fuel that may have spilled during
this procedure.
7 Swing the engine back to its original position
and close the engine pivot plate latch.
8 Install the engine pivot plate safety pin
(if equipped).
9 Start the engine from the ground controls, then
inspect the fuel filter and hoses for leaks.
Explosion and fire hazard. If a fuel
leak is discovered, keep any
additional personnel from entering
the area and do not operate the
machine. Repair the leak
immediately.
Part No. 52709