Genie Z-45/25 Service Manual page 436

Section 7 • Repair Procedures
4WD STEERING AXLE COMPONENTS
13 Remove the drive hub mounting fasteners that
attach the yoke to the drive hub. Remove the
yoke weldment from the drive hub.
Replace the thrust washer when
installing the yoke/drive hub
assembly onto the axle.
Torque specifications
Lug nut,
dry
lubricated
Drive hub mounting bolts,
dry
lubricated
Drive motor mounting bolts,
dry
lubricated
7 - 88
125 ft-lbs 169.5 Nm
94 ft-lbs 127.4 Nm
120 ft-lbs 163 Nm
90 ft-lbs 122 Nm
75 ft-lbs 102 Nm
56 ft-lbs 76 Nm
Genie Z-45/25 & Genie Z-45/25J
First Edition • Second Printing
16-2
Steering Cylinders
How to Remove a
Steering Cylinder
This procedure is the same as the 2WD procedure.
See repair procedure 15-2,
How to Remove a Steering Cylinder .
16-3
Tie Rod
How to Remove the Tie Rod
This procedure is the same as the 2WD procedure.
See Repair Procedure 15-3,
How to Remove the Tie Rod .
Part No. 52709