Chapter 1
Installing the Modules
1-8
Figure 1-5. Installing the Cable Management Bracket
3. Tighten the rack-mount pan head screws.
4. Thread the cables through the bracket to secure.
To install modules into the switch chassis:
1. Carefully remove each module from its shipping carton.
Leave the module wrapped in its antistatic bag.
* Note: Refer to
earlier in this chapter before removing the
module from the antistatic bag.
2. Carefully remove the module from the antistatic bag.
Avaya P550R/P580/P880/P882 MultiService Switch Installation Guide, v5.3
Cable Management
Preventing Electrostatic Discharge
Bracket