Enabling And Disabling Protocols - Ricoh Aficio SP 5200DN Operation And Use Manual

7. Enhanced Network Security
6. Click [Logout].
7. Close Web Image Monitor.

Enabling and Disabling Protocols

This can be specified by the network administrator.
Specify whether to enable or disable the function for each protocol. By making this setting, you can specify
which protocols are available and so prevent unauthorized access over the network.
Network settings can be specified on the control panel, or using Web Image Monitor, telnet,
SmartDeviceMonitor for Admin or Remote Communication Gate S. If you use SmartDeviceMonitor for
Admin, start Web Image Monitor from SmartDeviceMonitor for Admin and configure the settings from
there. For details about making settings using SmartDeviceMonitor for Admin or Remote Communication
Gate S, see the Help for each application. For details about making settings using telnet, see "Remote
Maintenance Using telnet", UNIX Supplement.
To disable SMTP on Web Image Monitor, in E-mail settings, set the protocol to anything other than SMTP.
For details, see Web Image Monitor Help.
For details about logging in and logging out with administrator authentication, see p.22 "Using Web Image
Monitor to Configure Administrator Authentication", p.25 "Logging in Using Administrator
7
Authentication", p.25 "Logging out Using Administrator Authentication".
Protocol
IPv4
IPv6
82
Port
-
-
Setting Method
• Control Panel
• Web Image Monitor
• telnet
• SmartDeviceMonitor
for Admin
• Remote
Communication Gate S
• Control Panel
• Web Image Monitor
• telnet
• SmartDeviceMonitor
for Admin
• Remote
Communication Gate S
Disabled Condition
All applications that
operate over IP cannot
be used.
If you are using IPv4, it
cannot be disabled on
Web Image Monitor.
All applications that
operate over IPv6
cannot be used.