5. Configuration
Wireless LAN Configuration
• Ethernet and Wireless LAN cannot be used at the same time.
• To use Wireless LAN, set as follows using the control panel: press the [Menu] key, select [Host
Interface], [Network], [LAN Type], and then select [Wireless LAN]. In addition, you must set the IP
address, subnet mask, gateway address, DHCP, Frame Type (NW), and active protocol as explained
in p.75 "Ethernet Configuration".
• The following table shows the control panel settings and their defaults. These items appear in the
[Wireless LAN] under [Host Interface] menu.
Communication Mode
5
SSID Setting
Ad-hoc Channel
Security Method
Wireless LAN Signal
Restore Defaults
1.
Press the [Menu] key.
2.
Press the [ ] or [ ] key to select [Host Interface], and then press the [OK] key.
84
Setting Name
Infrastructure Mode
blank
11
Off
-
-
CEC216
Default