Ricoh Aficio SP 5200DN Operation And Use Manual page 195

Cannot connect=>Comm.Serv. Check proxy user/password.
The proxy user name or password is incorrect. Check the proxy server settings, and change the user name
and/or password if they are incorrect.
Cannot connect with DHCP server.(101/201)
Cannot obtain IP address from DHCP server. Consult your network administrator.
Cannot connect with NetWare print server. (107/207)
Connection with NetWare print server is unavailable.
Cannot connect with NetWare server.(106/206)
Connection with NetWare server is unavailable. Consult your network administrator.
Cannot print.
Check the file you want to print is a supported file type. Check for misfeeds and ask your network
administrator for help.
Check network settings.(103/203)
The IP address setting is incorrect. Check the IP address, subnet mask, and gateway address. For details,
see p.75 "Ethernet Configuration".
Classification Code Error
A classification code is not specified for the print job. Enter a classification code using the printer properties
and print the document again.
For details, see "Registering Classification Codes", Software Guide.
Connect failed:WirelessCard Turn power off, check card.
Check there is a Wireless LAN board installed.
Check that it is a supported board. If it is, check it is installed correctly.
Install the correct board properly. For details, see p.59 "Installing the Interface Units".
Cover Open. Please close the indicated cover.
Close the cover indicated on the control panel.
Duplex mode is in off position for (tray name)
The duplex mode for the indicated tray is off; you can only use one-sided printing. Press [Change] to change
the tray's settings, press [JobReset] to reset the job, or press [Form Feed] to force printing.
Ethernet Board Error
An error on the Ethernet board is detected. Pull out and then re-install the controller board. If the problem
persists, contact your sales or service representative.
Error and Status Messages Appear on the Control Panel
9
173