Ricoh Aficio SP 5200DN Operation And Use Manual page 772

2. Remote Maintenance Using telnet
msh> set nrs
msh> set rfu
msh> set rfu6
msh> set nbt
msh> set ssdp
2
msh> set ssh
msh> set sftp
msh> set sftp6
msh> set wsdev
msh> set wsdev6
msh> set wsprn
msh> set ipds
msh> set rhpp
msh> set rhpp6
msh> set lltd
Configuration
• Enter "up" to enable the protocol, and enter "down" to disable the protocol.
You can set the protocol to "active" or "inactive".
msh> set ipv4 {up | down}
• If you disable IPv4, you cannot use remote access after logging off. If you did this by mistake,
you can use the control panel to enable remote access via IPv4.
• Disabling IPv4 also disables lpr, ftp, rsh, diprint, web, snmp, ssl, ipp, http, bonjour, and sftp.
msh> set ipv6 {up | down}
• If you disable IPv6, you cannot use remote access after logging off. If you did this by mistake,
you can use the control panel to enable remote access via IPv6.
• Disabling IPv6 also disables lpr6, ftp6, rsh6, diprint6, ssl6, ipp6, http6, and sftp6.
msh> set appletalk {up | down}
msh> set netware {up | down}
msh> set smb {up | down}
msh> set lpr {up | down}
msh> set lpr6 {up | down}
msh> set ftp {up | down}
msh> set ftp6 {up | down}
msh> set rsh {up | down}
62