Ricoh Aficio SP 5200DN Operation And Use Manual page 776

2. Remote Maintenance Using telnet
Display
msh> snmp ?
Community name configuration
msh> snmp "number" name "community_name"
• You can configure ten SNMP access settings numbered 1-10.
2
• The printer cannot be accessed from SmartDeviceMonitor for Admin or SmartDeviceMonitor for
Client if "public" is not registered in numbers 1-10. When changing the community name, use
SmartDeviceMonitor for Admin and SNMP Setup Tool to correspond with printer settings.
• The community name can be entered using up to 15 characters.
Deleting community name
msh> snmp "number" clear name
Access type configuration
msh> snmp "number" type "access_type"
no
read
write
trap
Protocol configuration
Use the following command to set protocols "active" or "inactive". If you set a protocol "inactive", all
access settings for that protocol are disabled.
msh> snmp {ipv4|ipv6|ipx} {on|off}
• Specify "ipv4" for IPv4, "ipv6" for IPv6, or "ipx" for IPX/SPX.
• {on} means "active" and {off} means "inactive".
• All protocols cannot be turned off concurrently.
Configuration of protocol for each registration number
To change the protocol of access settings, use the following command. However, if you have disabled
a protocol with the above command, activating it here has no effect.
msh> snmp "number" active {ipv4|ipv6|ipx} {on|off}
Access configuration
msh> snmp "number" {ipv4|ipv6|ipx} "address"
• You can configure a host address according to the protocol used.
66
Access type Type of access permission
not accessible
read only
read and write
user is notified of trapmessages