Installing The Rear-Mounting Brackets; Router Installed In The Rack; Installing The Unit In A 21-In. Etsi Rack - Juniper MX204 Hardware Manual

Installing the MX204 in a 21-in. ETSI Rack
Copyright © 2018, Juniper Networks, Inc.
The rear-mounting brackets on each side of the chassis are movable. You can adjust
the brackets according to the depth of the rack.
Figure 23: Installing the Rear-Mounting Brackets
Install mounting screws into each of the open rear-mounting holes aligned with the
9.
rack, starting from the bottom, and secure them tightly.
Visually inspect the alignment of the chassis. If the chassis is installed properly in the
10.
rack, all the mounting screws on one side of the rack are aligned with the mounting
screws on the opposite side and the router is level.
router fully secured and installed in a four-post rack.
Figure 24: Router Installed in the Rack
The ETSI racks are little wider than the standard 19-in. rack. To install the router in an
ETSI rack, you need to install the ETSI brackets on to the router.
shows the ETSI brackets supported by MX204 router.
Figure 25: ETSI Brackets
Chapter 12: Installing the Router
Figure 24 on page 67 shows the
Figure 25 on page 67
67