Figure 65: Lcd Panel In An Ex3200, Ex4200, Ex4500, Ex4550, Or Ex8200; Figure 66: Lcd Panel In An Ex4300 Switch - Juniper EX4300 Hardware Manual

EX4300 Switch Hardware Guide
220
To connect and configure the switch by using the J-Web interface:
Transition the switch into initial setup mode:
1.
EX2200 and EX2200-C switch—Press the mode button located on the lower right
corner of the front panel for 10 seconds.
EX3200, EX3300, EX4200, EX4300, EX4500, EX4550, EX6200, or EX8200
switch—Use the
Menu
Figure 65 on page 220

Figure 65: LCD Panel in an EX3200, EX4200, EX4500, EX4550, or EX8200

Switch

Figure 66: LCD Panel in an EX4300 Switch

1— LCD panel
2— LCD panel Enter button
Press the button until you see
Menu
1.
button.
Press until you see
2. Menu
If EZSetup does not appear as an option in the menu, select
return the switch to the factory default configuration. EZSetup is displayed in
the menu of standalone switches only when a switch is set to the factory default
configuration.
Press to confirm setup and continue with EZSetup.
3. Enter
Connect the Ethernet cable from the Ethernet port on the PC to the switch.
2.
EX2200, EX3200, or EX4200 switch—Connect the cable to port 0 (ge-0/0/0) on
the front panel of the switch.
EX3300, EX4500, or EX4550 switch—Connect the cable to the port labeled
on the front panel (LCD panel side) of the switch.
EX4300 switch—Connect the cable to the port labeled
the switch.
and buttons located to the right of the LCD panel (see
Enter
or Figure 66 on page 220):
3— LCD panel Menu button
4— Chassis status LEDs
MAINTENANCE MENU
. Then press
ENTER EZSetup
. Then press the
.
Enter
Factory Default
on the rear panel of
MGMT
Copyright © 2017, Juniper Networks, Inc.
Enter
to
MGMT