Replacing The Cutter - Epson SureColor SC-F6300 Series User Manual

SC-F6300 Series User's Guide
H
Follow the instructions on the control panel
screen to open the printer cover and remove the
two cleaning pads.
c
Important:
❏ Remove them carefully so that no dirt gets
on the surrounding area.
❏ Check the platen and clean it if it is dusty
or dirty.
"Cleaning the platen" on page 72
U
Do not reuse the cleaning pads.
"Handling Used Consumables" on
U
page 89
I
Close the printer cover, and then press the Z
button.
Head cleaning starts. When the procedure is
complete, head cleaning is finished.

Replacing the Cutter

Replace the cutter when it is not cutting paper cleanly.
Supported cutter
"Options and Consumable Products" on
U
page 99
Use a cross-head screwdriver to replace the cutter. Make
sure you have a cross-head screwdriver with you before
replacing the cutter.
c
Important:
❏ Take care not to damage the cutter blade.
Dropping it or knocking it against hard objects
may chip the blade.
❏ The sheets between the new cutters are to
protect the blades.
Do not remove the sheet while replacing the
cutter.
Read the following before starting this procedure.
"Precautions Regarding Maintenance" on page 65
U
Maintenance
Buttons that are used in the following settings
A
Confirm that the printer is ready to print. Use the
l/r buttons to select -, and then press the Z
button.
The Maintenance menu is displayed.
B
Use the d/u buttons to select Cutter
Maintenance, and then press the Z button.
C
Use the d/u buttons to highlight Replace Cutter
and press the Z button.
D
The cutter will move to the replacement position.
E
Remove the old cutter from the printer.
Loosen the screw holding the cutter in place
using a cross-head screwdriver and pull the
cutter straight out.
Caution:
Do not store the cutter within the reach of
children. The cutter's blade could cause an
injury. Pay careful attention when replacing
the cutter.
87