Clear Snoop Map; Set Snoop - D-Link DWS-1008 Cli Reference Manual

clear snoop map

Removes a snoop filter from an AP radio.
Examples: clear snoop map filter-name dap dap-num radio {1 | 2}
filter-name Name of the snoop filter.
dap dap-num
radio 1
radio 2
Defaults: None.
Access: Enabled.
Examples: The following command removes snoop filter snoop2 from radio 2 on
Distributed AP 3:
DWS-1008# clear snoop map snoop2 dap 3 radio 2
success: change accepted.
The following command removes all snoop filter mappings from all radios:
DWS-1008# clear snoop map all
success: change accepted.
See Also:
• set snoop map
• show snoop
• show snoop map

set snoop

Configures a snoop filter.
Syntax: set snoop filter-name [condition-list] [observer ip-addr] [snap-length num]
filter-name
D-Link DWS-1008 CLI Manual
Number of a Distributed AP to which to snoop filter is mapped.
Radio 1 of the AP.
Radio 2 of the AP. (This option does not apply to single-radio models.)
Name for the filter. The name can be up to 15 alphanumeric characters,
with no spaces.