D-Link DWS-1008 Cli Reference Manual page 415

Output for show ap status terse and show dap status terse
Field
Port
Flg
IP Address
Model
MAC Address
Radio1
Radio2
Uptime
show auto-tune attributes
Displays the current values of the RF attributes RF Auto-Tuning uses to decide whether to change
channel or power settings.
Syntax show auto-tune attributes [ap mp-num [radio {1 | 2| all}]]
Syntax show auto-tune attributes [dap dap-num [radio {1 | 2| all}]]
mp-num
dap-num
radio1
radio2
radio all
Defaults None.
Access Enabled.
D-Link DWS-1008 CLI Manual
DWS-1008AP port number connected to the AP.
Operational status flags for the AP.
For flag definitions, see the key in the command output.
IP address of the AP. The address is assigned to the AP by a DHCP server.
Note: This field is applicable only if the AP is configured on the DWS-1008 as
a Distributed AP.
AP model number.
MAC address of the AP.
State, channel, and power information for radio 1:
• The state can be D (disabled) or E (enabled).
• The channel and power settings are shown as channel/power.
State, channel, and power information for radio 2.
Amount of time since the AP booted using this link.
AP port connected to the AP access point for which to display RF attributes.
Number of a Distributed AP for which to display RF attributes.
Shows RF attribute information for radio 1.
Shows RF attribute information for radio 2.
Shows RF attribute information for both radios.
Description
1