D-Link DWS-1008 Cli Reference Manual page 56

set port type wired-auth
Configures an DWS-1008 port for a wired authentication user.
Syntax: set port type wired-auth port-list [tag tag-list] [max-sessions num]
[auth-fall-thru {last-resort | none | web-portal}]
port-list
tag-list
num
last-resort
none
web-portal
Defaults: The default tag-list is null (no tag values). The default number of sessions is 1. The
default fallthru authentication type is none.
Access: Enabled.
Usage: You cannot set a port's type if the port is a member of a port VLAN. To remove a port
from a VLAN, use the clear vlan command. To reset a port as a network port, use the clear
port type command.
When you change port type, MSS applies default settings appropriate for the port type.
The following Table lists the default settings that MSS applies when you set a port's type to
wired-auth.
Wired Authentication Port Defaults:
Port Parameter
VLAN Membership
Spanning Tree Protocol
(STP)
802.1x
Port Groups
IGMP Snooping
Maximum user
sessions
Fallthru Auth type
D-Link DWS-1008 CLI Manual
List of physical ports.
One or more numbers between 1 and 4094 that subdivide a wired
authentication port into virtual ports.
Maximum number of simultaneous user sessions supported.
Automatically authenticates the user without requiring a user name and
password.
Denies authentication and prohibits the user from accessing the network
over this port.
Serves the user a web page from the DWS-1008's nonvolatile storage
for a secure login to the network.
Removed from all VLANs. You cannot assign an AP access port to a
VLAN. MSS automatically assigns AP access ports to VLANs based on
user traffic.
Not applicable.
Uses authentication parameters configured for users.
Not applicable.
Enabled as users are authenticated and join VLANs.
One (1)
None
Setting