D-Link DWS-1008 Cli Reference Manual page 417

show auto-tune neighbors
Displays the other D-Link access point and third-party 802.11 access points that a D-Link access
point can hear.
Syntax: show auto-tune neighbors [ap mp-num [radio {1 | 2| all}]]
Syntax: show auto-tune neighbors [dap dap-num [radio {1 | 2| all}]]
mp-num
dap-num
radio1
radio2
radio all
Defaults: None.
Access: Enabled.
Usage: For simplicity, this command displays a single entry for each D-Link radio, even if the
radio is supporting multiple BSSIDs. However, BSSIDs for third-party 802.11 radios are listed
separately, even if a radio is supporting more than one BSSID.
Information is displayed for a radio if the radio sends beacon frames or responds to probe requests.
Even if a radio's SSIDs are unadvertised, D-Link radios detect the empty beacon frames (beacon
frames without SSIDs) sent by the radio, and include the radio in the neighbor list.
Examples: The following command displays neighbor information for radio 1 on the directly
connected AP access point on port 2:
DWS-1008# show auto-tune neighbors ap 2 radio 1
Total number of entries for port 2 radio 1: 5
Channel Neighbor BSS/MAC RSSI
----------- ---------------------------- ------
1
1
1
1
1
D-Link DWS-1008 CLI Manual
AP port connected to the AP access point for which to display neighbors.
Number of a Distributed AP for which to display neighbors.
Shows neighbor information for radio 1.
Shows neighbor information for radio 2.
Shows neighbor information for both radios.
00:0b:85:06:e3:60
00:0b:0e:00:0a:80
00:0b:0e:00:d2:c0
00:0b:85:06:dd:00
00:0b:0e:00:05:c1
-46
-78
-74
-50
-72
1