D-Link DWS-1008 Cli Reference Manual page 400

The following Table describes the fields in this display.
Field
port
DAP
serial-id
AP Model
POE
name
fingerprint
boot-download-enable
force-image-download
load balancing group
location
contact
Radio
type
channel
antennatype
tx pwr
profile
auto-tune max-power
D-Link DWS-1008 CLI Manual
DWS-1008 port number.
Note: This field is applicable only if the DWL-8220AP is directly connected to the
DWS-1008 and the DWS-1008's port is configured as an AP access port.
Connection ID for the Distributed AP.
This field is applicable only if the AP is configured on the DWS-1008 as a Distributed
AP.
Serial ID of the DWL-8220AP access point.
Note: This field is displayed only for Distributed APs.
Access point mdel number.
PoE state on the DWS-1008 port:
• Enable
• Disable
DWL-8220AP access point name.
Hexadecimal fingerprint of the AP's public encryption key.
Note: This field is displayed only for Distributed APs. If the field is blank, the key has
not been verified yet by an administrator.
State of the firmware upgrade option:
• YES (automatic upgrades are enabled)
• NO (automatic upgrades are disabled)
State of the option to force the AP to download a new image:
• YES (automatic upgrades are enabled)
• NO (automatic upgrades are disabled)
Names of the AP load-balancing groups to which the DWL-8220AP access point
belongs. If the value is None, the access point does not belong to any load balancing
groups.
Location information for the AP.
Contact information for the AP.
Radio number. The information listed below this field applies specifically to the radio.
Radio type:
• 802.11a
• 802.11b
• 802.11g
Channel number.
External antenna model, if applicable.
Transmit power, in dBm.
Radio profile that manages the radio. Until you assign the radio to a radio profile,
MSS, assigns the radio to the default radio profile.
Maximu power level the RF Auto-Tuning feature can set on the radio:
• The value default means RF Auto-Tuning can set the power up to the maximum level
allowed for the country of operation.
• A specific numeric value means you or another administrator set the maximum
value.
Description