D-Link DWS-1008 Cli Reference Manual page 424

show radio-profile
Displays radio profile information.
Syntax: show radio-profile {name | ?}
Displays information about the named radio profile.
name
? Displays a list of radio profiles.
Defaults: None.
Access: Enabled.
Usage: MSS contains a default radio profile. D-Link recommends that you do not change this
profile but instead keep the profile for reference.
Examples: The following command shows radio profile information for the default radio profile:
DWS-1008# show radio-profile default
Beacon Interval:
Max Tx Lifetime:
RTS Threshold:
Long Preamble:
Tune Power:
Tune Power Interval:
Channel Holddown:
Active-Scan:
WMM Powersave:
No service profiles configured.
The following table describes the fields in the display:
Field
Beacon Interval
DTIM Interval
Max Tx Lifetime
Max Rx Lifetime
D-Link DWS-1008 CLI Manual
100 DTIM Interval:
2000 Max Rx Lifetime:
2346 Frag Threshold:
no Tune Channel:
no Tune Channel Interval:
600 Power ramp interval:
300
yes RFID enabled:
no QoS Mode:
Rate (in milliseconds) at which each AP radio in the profile advertises the
beaconed SSID.
Number of times after every beacon that each AP radio in the radio profile sends
a delivery traffic indication map (DTIM).
Number of milliseconds that a frame received by a radio in the radio profile can
remain in buffer memory.
Number of milliseconds that a frame scheduled to be transmitted by a radio in
the radio profile can remain in buffer memory.
1
2000
2346
yes
3600
60
Countermeasures:
no
wmm
Description
none
1