D-Link DWS-1008 Cli Reference Manual page 379

set service-profile shared-key-auth
Enables shared-key authentication, in a service profile.
Note. Use this command only if advised to do so by D-Link. This command does not enable
preshared key (PSK) authentication for Wi-Fi Protected Access (WPA). To enable PSK encryption
for WPA, use the set service-profile auth-psk command.
Syntax: set service-profile name shared-key-auth {enable | disable}
name
enable
disable
Defaults: Shared-key authentication is disabled by default.
Access: Enabled.
Usage: Shared-key authentication is supported only for encrypted SSIDs. In addition, if you
enable shared-key authentication, RSN, WPA, TKIP, and CCMP must be disabled. By default,
RSN, WPA, and CCMP are already disabled, but TKIP is enabled; you must manually disable
TKIP. To disable TKIP, use the set service-profile cipher-tkip disable command.
Examples: The following command enables shared-key authentication in service profile sp4:
DWS-1008# set service-profile sp4 shared-key-auth enable
success: change accepted.
See Also:
• set radio-profile mode
• set service-profile cipher-tkip
• show service-profile
set service-profile short-retry-count
Changes the short retry threshold for a service profile. The short retry threshold specifies the
number of times a radio can send a short unicast frame without receiving an acknowledgment. A
short unicast frame is a frame that is shorter than the frag-threshold.
Syntax: set service-profile name short-retry-count threshold
D-Link DWS-1008 CLI Manual
Service profile name.
Enables shared-key authentication.
Disables shared-key authentication.