clear radius
Resets parameters that were globally configured for RADIUS servers to their default values.
Syntax: clear radius {deadtime | key | retransmit | timeout}
deadtime
key
retransmit
timeout
Defaults: Global RADIUS parameters have the following default values:
deadtime—0 (zero) minutes (The switch does not designate unresponsive RADIUS
•
servers as unavailable.)
key—No key
•
retransmit—3 (the total number of attempts, including the first attempt)
•
•
timeout—5 seconds
Access: Enabled.
Usage: To override the globally set values on a particular RADIUS server, use the set radius
server command.
Examples: To reset all global RADIUS parameters to their factory defaults, type the following
commands:
DWS-1008# clear radius deadtime
success: change accepted.
DWS-1008# clear radius key
success: change accepted.
DWS-1008# clear radius retransmit
success: change accepted.
DWS-1008# clear radius timeout
success: change accepted.
D-Link DWS-1008 CLI Manual
Number of minutes to wait after declaring an unresponsive RADIUS server
unavailable before retrying the RADIUS server.
Password (shared secret key) used to authenticate to the RADIUS server.
Number of transmission attempts made before declaring an unresponsive
RADIUS server unavailable.
Number of seconds to wait for the RADIUS server to respond before
retransmitting.
8