Show Config - D-Link DWS-1008 Cli Reference Manual

The table below describes the fields in the show boot output.
Field
Configured boot version
Configured boot image
Configured boot
configuration
Backup boot
configuration
Booted version
Booted image
Booted configuration
See Also:
• clear boot config
• reset system
• set boot configuration-file

show config

Displays the configuration running on the switch.
Syntax: show config [area area] [all]
area area
D-Link DWS-1008 CLI Manual
Software version the switch will run next time the software is rebooted.
Boot partition and image filename MSS will use to boot next time the software is
rebooted.
Configuration filename MSS will use to boot next time the software is rebooted.
The name of the configuration file to be used in the event that MSS cannot read the
configured boot configuration file next time the software is rebooted.
Software version the switch is running.
Boot partition and image filename MSS used the last time the software was
rebooted. MSS is running this software image.
Configuration filename MSS used to load the configuration the last time the software
was rebooted.
Configuration area. You can specify one of the following:
• aaa
• acls
• ap
• arp
• eapol
• httpd
• ip
• ip-config
• l2acl
• log
• mobility-domain
• network-domain
• ntp
• portconfig
• port-group
• qos
• radio-profile
• rfdetect
• service-profile
• sm
• snmp
• snoop
Description
0