D-Link DWS-1008 Cli Reference Manual page 356

Table: Defaults for Radio Profile Parameters (continued)
Parameter
cac-mode
cac-session
cipher-ccmp
cipher-tkip
cipher-wep104
cipher-wep40
cos
dhcp-restrict
idle-client-probing
keep-initial-vlan
long-retry-count
no-broadcast
proxy-arp
D-Link DWS-1008 CLI Manual
Default Value
Does not limit the number of active user sessions based on Call
none Admission Control.
If session-based CAC is enabled (cac-mode is set to session),
limits the number of active user sessions on a radio to 14.
14
Does not use Counter with Cipher Block Chaining Message
Authentication Code Protocol (CCMP) to encrypt traffic sent to
disable
WPA clients.
When WPA IE is enabled, uses Temporal Key Integrity Protocol
(TKIP) to encryp traffic sent to WPA clients.
enable
Does
disable
104-bit keys to encrypt traffic sent to WPA clients.
Does not user WEP with 40-bit keys to encrypt traffic sent to WPA
disable
clents.
If static CoS is enabled (static-cos is set to enable) assigns CoS
0 to all data traffic to or from clients.
Does not restrict a client's traffic to only DHCP traffic while the
client is being authenticated and authorized.
disable
Sends a keepalive packet (a null-data frame) to each client every
enable
10 seconds.
Reassigns the user to a VLAN after roaming, instead of leaving
the roamed user on the VLAN assigned by the switch where the
user is logged on.
disable
Note: Enabling the option does not retain the user's initial VLAN
assignment in all cases.
Sends a long unicast frame up to five times without
5
acknowledgement.
Does not reduce wireless broadcast traffic by sending unicasts to
clients for ARP requests and DHCP Offers and Acks instead of
disable forwarding them as multicasts.
Does not reply on behalf of wireless clients to ARP requests for
client IP addresses. Instead, the radio forwards the ARP Requests
disable as wireless broadcasts.
Radio Behavior When Parameter Set to Default Value
not use Wired Equivalent Privacy with