Port Parameter
VLAN membership
Spanning Tree Protocol
(STP)
802.1X
Port groups
Internet Group
Management Protocol
(IGMP) snooping
Access: point and radio
parameters
Maximum user sessions Not applicable.
Examples: The following command clears port 5:
DWS-1008# clear port type 5
This may disrupt currently authenticated users. Are you sure? (y/n) [n]y
success: change accepted.
See Also:
• set port type ap
• set port type wired-auth
D-Link DWS-1008 CLI Manual
Setting
None.
Note: Although the command changes a port to a network port, the
command does not place the port in any VLAN. To use the port in a VLAN,
you must add the port to the VLAN.
Based on the VLAN(s) you add the port to.
No authorization.
None.
Enabled as port is added to VLANs.
Not applicable.