D-Link DWS-1008 Cli Reference Manual page 411

show {ap | dap} status
Displays DWL-8220AP access point and radio status information.
Syntax: show ap status [terse] | [port-list | all [radio {1 | 2}]]
Syntax: show dap status [terse] | [dap-num | all [radio {1 | 2}]]
terse
Displays a brief line of essential status information for each AP.
port-list
List of ports connected to the DWL-8220AP access point(s) for which to display
status.
dap-num
Number of a Distributed AP for which to display status.
all
Shows status information for all directly attached DWL-8220AP access points
and all Distributed AP access points configured on the switch.
radio1
Shows status information for radio 1.
radio2
Shows status information for radio 2. (This option does not apply to single-radio
models.)
Defaults: None.
Access: Enabled.
Examples: The following command displays the status of a Distributed AP access point:
DWS-1008# show dap status 1
Dap: 1, IP-addr: 10.2.30.5 (vlan 'vlan-corp'), AP model: DWL-8220AP,
manufacturer: D-Link, name: DAP01
fingerprint: b4:f9:2a:52:37:58:f4:d0:10:75:43:2f:45:c9:52:c3
====================================================
State: operational (not encrypted) CPU info: IBM:PPC speed=266666664 Hz
version=405GPrid=0x29c15335347f1919 ram=33554432 s/n=0333703027 hw_rev=A3
Uptime: 18 hours, 36 minutes, 27 seconds
Radio 1 type: 802.11g, state: configure succeed [Enabled] (802.11b protect)
operational channel: 1 operational power: 14 base mac: 00:0b:0e:00:d2:c0
bssid1: 00:0b:0e:00:d2:c0, ssid: public bssid2: 00:0b:0e:00:d2:c2, ssid: employee-net
bssid3: 00:0b:0e:00:d2:c4, ssid: mycorp-tkip
Radio 2 type: 802.11a, state: configure succeed [Enabled] operational channel: 64
operational power: 14 base mac: 00:0b:0e:00:d2:c1 bssid1: 00:0b:0e:00:d2:c1, ssid:
public bssid2: 00:0b:0e:00:d2:c3, ssid: employee-net bssid3: 00:0b:0e:00:d2:
D-Link DWS-1008 CLI Manual 08