D-Link DWS-1008 Cli Reference Manual page 518

HA=ip-addr
FL=num
OPT=option
OPT+=option
Defaults: The boot settings in the currently active boot profile are used by default.
Access: Boot prompt.
Usage: If you use an optional parameter, the parameter setting overrides the setting of the same
parameter in the currently active boot profile. However, the boot profile itself is not changed. To
display the currently active boot profile, use the show command. To change the currently active
boot profile, use the change command.
Examples: The following command loads system image file MX010101.020 from boot
partition 1:
boot> boot FN=MX010101.020 DEV=boot1
Compact Flash load from boot1:testcfg matches MX010101.020.
unzip: Inflating ramdisk_1.1.1.. OK
unzip file len 36085486 OK
Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003
The NetBSD Foundation, Inc. All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
Power Cycle Reboot
Detecting hardware...done.
readclock: 2003-10-8 2:9:50.67 UTC=>1065578990.670000 (1064992894)
init: Creating mfs /dev
erase ^H, werase ^W, kill ^U, intr ^C, status ^T
Doing D-Link mounts and links
Starting nos_mon...
nos_mon:ps: not found
SYSLOGD Oct 08 02:10:05.477814 CRITICAL SYSTEM_READY: The system has
finished booting.
Copyright (c) 2002, 2003
D-Link System, Inc.
Username:
Password:
D-Link DWS-1008 CLI Manual
Host address (IP address) of a TFTP server. This parameter applies only
when the boot type is n (network).
Number representing the bit settings of boot flags to pass to the booted
system image. Use this parameter only if advised to do so by D-Link.
String up to 128 bytes of boot options to pass to the booted system image
instead of the boot option(s) in the currently active boot profile. The options
temporarily replace the options in the boot profile. Use this parameter only if
advised to do so by D-Link.
String up to 128 bytes of boot options to pass to the booted system image in
addition to the boot option(s) in the currently active boot profile. The options
are appended to the options already in the boot profile. Use this parameter
only if advised to do so by D-Link.
1