D-Link DWS-1008 Cli Reference Manual page 60

show port poe
Displays status information for ports on which Power over Ethernet (PoE) is enabled.
Syntax: show port poe [port-list]
port-list List of physical ports. If you do not specify a port list, PoE information is displayed
for all ports.
Defaults: None.
Access: All.
Examples: The following command displays PoE information for all ports on a DWS-1008:
DWS-1008# show port poe
Link
Port Name Status
==============================================================
1 1 up
2 2 down
3 3 down
4 4 down
5 5 down
6 6 up
7 7 down
8 8 down
The table below describes the fields in this display.
Field
Port
Name
Link status
Port type
PoE config
PoE Draw
D-Link DWS-1008 CLI Manual
Port PoE
Type config
- disabled
- disabled
- disabled
- disabled
- disabled
AP enabled
- disabled
- disabled
Description
Port number.
Port name. If the port does not have a name, the port number is
listed.
Link status of the port:
• up—The port is connected.
• down—The port is not connected.
Port type:
• AP—The port is an AP access port.
• - (The port is not an AP access port.)
PoE state:
• enabled
• disabled
Power draw on the port, in watts.
For 10/100 Ethernet ports on which PoE is disabled, this field
displays off. The value overcurrent indicates a PoE problem
such as a short in the cable.
PoE
Draw
off
off
off
off
off
1.44
invalid
invalid