D-Link DWS-1008 Cli Reference Manual page 528

show
Displays the currently active boot profile. A boot profile is a set of parameters that a switch uses
to control the boot process. Each boot profile contains the following parameters:
• Boot type—Either compact flash (local device on the switch) or network (TFTP)
• Boot device—Location of the system image file
• Filename—System image file
• Flags—Number representing the bit settings of boot flags to pass to the booted system
image.
• Options—String up to 128 bytes of boot options to pass to the booted system image
A DWS-1008 switch can have up to four boot profiles, numbered 0 through 3. Only one boot
profile can be active at a time. You can create, change, and delete boot profiles. You also can
activate another boot profile in place of the currently active one.
Syntax: show
Defaults: None.
Access: Boot prompt.
Examples: To display the currently active boot profile, type the following command at the boot
prompt:
boot> show
BOOT Index:
BOOT TYPE:
DEVICE: boot
FILENAME:
FLAGS:
OPTIONS:
The following is an example of a boot profile that is booted with a software image downloaded
from a TFTP server. In the example, when the switch boots, it downloads a system image file
called bootfile located on a TFTP server with address 172.16.0.1.
boot> show
BOOT Index:
BOOT TYPE:
DEVICE:
FILENAME:
HOST IP:
LOCAL IP:
GATEWAY IP:
IP MASK:
FLAGS:
OPTIONS:
D-Link DWS-1008 CLI Manual
0
c
1:
default
00000000
run=nos;boot=0
0
n
emac1
bootfile
172.16.0.1
172.16.0.21
172.16.0.20
255.255.255.0
00000000
run=nos