D-Link DWS-1008 Cli Reference Manual page 123

The table below describes the fields in this display.
Field
Interface
Configuration Status
DHCP State
Lease Allocation
Lease Remaining
IP Address
Subnet Mask
Default Gateway
DHCP Server
DNS Servers
DNS Domain Name
See Also:
• set interface dhcp-client
show dhcp-server
Displays MSS DHCP server information.
Syntax: show dhcp-server [interface vlan-id] [verbose]
interface vlan-id
verbose
Defaults: None.
Access: All.
Examples: The following command displays the addresses leased by the MSS DHCP server:
DWS-1008# show dhcp-server
VLAN Name
--------------------------------------------------------------------------------------------------------
1 default
1 default
2 red-vlan
2 red-vlan
D-Link DWS-1008 CLI Manual
VLAN name and number.
Status of the DHCP client on this VLAN:
• Enabled
• Disabled
State of the IP interface:
• IF_UP
• IF_DOWN
Duration of the address lease.
Number of seconds remaining before the address lease expires.
IP address received from the DHCP server.
Network mask of the IP address received from the DHCP server.
Default router (gateway) IP address received from the DHCP server. If the address
is 0.0.0.0, the server did not provide an address.
IP address of the DHCP server.
DNS server IP address(es) received from the DHCP server.
Default DNS domain name received from the DHCP server.
Displays the IP addresses leased by the specified VLAN.
Displays configuration and status information for the MSS DHCP server.
Address MAC
10.10.20.2 00:01:02:03:04:05 12345
10.10.20.3 00:01:03:04:06:07 2103
192.168.1.5 00:01:03:04:06:08 102
192.168.1.7 00:01:03:04:06:09 16789
Description
Lease Remaining (sec)
10