D-Link DWS-1008 Cli Reference Manual page 251

See Also:
• clear dot1x max-req
• show dot1x
set dot1x port-control
Determines the 802.1X authentication behavior on individual wired authentication ports or groups
of ports.
Syntax: set dot1x port-control {forceauth | forceunauth | auto} port-list
forceauth
forceunauth
auto
port-list
Defaults: By default, wired authentication ports are set to auto.
Access: Enabled.
Usage: This command affects only wired authentication ports.
Examples: The following command forces port 6 to unconditionally accept all 802.1X authentication
attempts:
DWS-1008# set dot1x port-control forceauth 6
success: authcontrol for 19 is set to FORCE-AUTH.
See Also:
• show port status
• show dot1x
D-Link DWS-1008 CLI Manual
Forces the specified wired authentication port(s) to unconditionally authorize
all 802.1X authentication attempts, with an EAP success message.
Forces the specified wired authentication port(s) to unconditionally reject all
802.1X authentication attempts with an EAP failure message.
Allows the specified wired authentication ports to process 802.1X
authentication normally as determined for the user by the set authentication
dot1X command.
One or more wired authentication ports for which to set 802.1X port
control.
8