D-Link DWS-1008 Cli Reference Manual page 145

SNMPv2c with Informs
To configure a notification target for informs from SNMPv2c, use the following command:
Syntax: set snmp notify target target-num ip-addr [:udp-port-number]
v2c community-string inform [profile profile-name] [retries num] [timeout num]
target-num
ip-addr [:udp-port-number]
community-string
profile profile-name
retries num
timeout num
SNMPv2c with Traps
To configure a notification target for traps from SNMPv2c, use the following command:
Syntax: set snmp notify target target-num ip-addr [:udp-port-number]
v2c community-string trap [profile profile-name]
target-num
ip-addr [:udp-port-number]
community-string
profile profile-name
D-Link DWS-1008 CLI Manual
ID for the target. This ID is local to the switch and does not
need to correspond to a value on the target itself. You
can specify a number from 1 to 10.
IP address of the server. You also can specify the UDP port
number to send notifications to.
Community string.
Notification profile this SNMP user will use to specify the
notification types to send or drop.
Specifies the number of times the MSS SNMP engine will
resend a notification that has not been acknowledged
by the target. You can specify from 0 to 3 retries.
Specifies the number of seconds MSS waits for
acknowledgement of a notification. You can specify from 1 to
5 seconds.
ID for the target. This ID is local to the switch and does not
need to correspond to a value on the target itself. You
can specify a number from 1 to 10.
IP address of the server. You also can specify the UDP port
number to send notifications to.
Community string.
Notification profile this SNMP user will use to specify the
notification types to send or drop.
1